Custom bandanas: which fabric, which print method and where should the logo go?
Three choices drive everything else: the fibre, how visible the logo stays once tied, and the back you can accept.
Cotton or polyester: the fibre sets the print method
Screen printing and digital printing work on cotton; sublimation only works on polyester [1][2], with at least 65% polyester according to one distributor [1]. A photo or a full-colour pattern therefore points you toward polyester, while a one- or two-colour logo suits cotton. According to a distributor and a seller guide from a B2B marketplace, sublimation dye becomes part of the fibre rather than sitting on top as a layer that can crack or peel [1][2]; no independent wash test was found. Before ordering in volume, have the exact fabric content confirmed [3].
Folded and tied, will the logo still show?
According to one distributor, a bandana is folded into a triangle far more often than it is worn flat: a corner design stays visible, while a centred design is meant to be worn or displayed flat [1][4]. Folds can swallow small text, so keep it clear of the fold lines and check on the proof that every logo, sponsors' included, is still readable [1][3].
What will the back look like?
According to one manufacturer, with water-based inks the design bleeds through to the back in a way that is neither controllable nor consistent [5]; on a screen printers' forum, one printer sees it as hard to avoid on a very thin bandana, while another reports avoiding it with their settings [6]. Single-sided digital printing or sublimation can leave the back white: that manufacturer says so for its digital printing [5], and a print-on-demand service specifies that its sublimation is done on one side [7]. If the bandana will be worn tied or resold, pick the method based on the back you can live with.
Logo colours: budget and contrast
A one-colour imprint is the most economical option [8][3], and according to that same manufacturer, most bandana designs stick to one or two colours [9]. In screen printing, cost generally rises with each added colour (to be confirmed with your quote); multicolour mainly pays off when several sponsors share the bandana [3]. According to a printer-distributor, bandanas are usually screen printed without a white underbase, so a light ink on a medium or dark fabric can look dull [8]. If bandana colour is how you'll tell teams or volunteers apart [4], choose it at the same time as the logo colour.
Bordered or edge-to-edge?
In screen printing, the printable area is often smaller than the square, leaving an unprinted border, according to that same manufacturer and a printer-distributor [9][8]. For edge-to-edge sublimation, one print service recommends a full-page image or a repeated logo pattern, since any empty area shows bare polyester [7]. A design that stops short of the edges should keep a generous margin: according to the same manufacturer, a hand-cut bandana isn't a perfect square and the fabric stretches [10].
Écran Blanc's advice
For an outdoor event and a simple logo, cotton printed in one or two colours in a corner is often a good place to start; for a photo, edge-to-edge sublimated polyester. Then review the proof while picturing the bandana folded and, if your date is fixed, start from the event and work the schedule backwards.